|
09-07-2015, 01:30 PM
|
#1
|
Ensign
Join Date: Mar 2015
Posts: 6
|
Maxum 2600SE Audiable Alarm Help
Hi All
I changed both my batterys 2 weeks ago, ever since I have an Audible alarm going off twice every sixty seconds.
This happens with the engine on or off.
Also at the weekend I ran the engine, once the engine was at temp I gave it a little Rev, then the alarm stopped.
So I switched it off, then back on again, the alarms started again.
Any ideas as to what the cause could be.
My local dealer cant come out for 3weeks to test.
All was fine before I changed the batterys, only changed them as they was dead.
Any help or advice welcome
__________________
|
|
|
09-07-2015, 04:32 PM
|
#2
|
Admiral
Join Date: Feb 2012
Location: Essex, Maryland
Posts: 10,632
|
Being that this has the newer alarm system I'll have to look for the codes as I do not recall them from memory, I know shrew has the list.
__________________
__________________
1997 Silverton 362, 7.4 Crusaders
1997 2400 SCR, 5.7 Vortec / Bravo 2
Mike
|
|
|
09-07-2015, 04:36 PM
|
#3
|
Admiral
Join Date: Feb 2012
Location: Essex, Maryland
Posts: 10,632
|
Ok quick seach says open or shorted sensor(s) and requires an engine scan. Did you bump any senser while changing the batteries?
__________________
1997 Silverton 362, 7.4 Crusaders
1997 2400 SCR, 5.7 Vortec / Bravo 2
Mike
|
|
|
09-07-2015, 06:43 PM
|
#4
|
Ensign
Join Date: Mar 2015
Posts: 6
|
Quote:
Originally Posted by mmwjr
Ok quick seach says open or shorted sensor(s) and requires an engine scan. Did you bump any senser while changing the batteries?
|
Not that I'm aware, how do I find out where they all are
|
|
|
09-08-2015, 12:33 AM
|
#5
|
Admiral
Join Date: Feb 2012
Location: Essex, Maryland
Posts: 10,632
|
Quote:
Originally Posted by Bullysrus
Not that I'm aware, how do I find out where they all are
|
Go to boatinfo.no and find the manual for your engine then look for sensers on the engine near the batteries.
__________________
1997 Silverton 362, 7.4 Crusaders
1997 2400 SCR, 5.7 Vortec / Bravo 2
Mike
|
|
|
10-08-2015, 03:20 PM
|
#6
|
Ensign
Join Date: Mar 2015
Posts: 6
|
All,
I haven't been able to get anyone out yet, but after reading I have changed the Idle Control Valve.
So, Now when the engine is running the alarm doesn't sound, but if you turn the ignition on the alarm still sounds and every minute.
So now I am confused even more........Help
|
|
|
10-08-2015, 05:08 PM
|
#7
|
Admiral
Join Date: Feb 2012
Location: Essex, Maryland
Posts: 10,632
|
The alarm will sound when the key is on but the engine is not running its a test function kind of like the idiot lights in your car that come on when starting.
As long as it goes off once the engine is running it is ok.
__________________
1997 Silverton 362, 7.4 Crusaders
1997 2400 SCR, 5.7 Vortec / Bravo 2
Mike
|
|
|
10-08-2015, 06:31 PM
|
#8
|
Ensign
Join Date: Mar 2015
Posts: 6
|
Quote:
Originally Posted by mmwjr
The alarm will sound when the key is on but the engine is not running its a test function kind of like the idiot lights in your car that come on when starting.
As long as it goes off once the engine is running it is ok.
|
Thanks
I get the single alarm, then a double alarm, then it goes off every 2 minutes.
But now when the engine runs it doesn't go off
|
|
|
10-08-2015, 09:59 PM
|
#9
|
Admiral
Join Date: Feb 2012
Location: Essex, Maryland
Posts: 10,632
|
Quote:
Originally Posted by Bullysrus
Thanks
I get the single alarm, then a double alarm, then it goes off every 2 minutes.
But now when the engine runs it doesn't go off
|
Not sure but it may be an old fault from the IAC that you replaced. If you had the reader you could clear the code, another method is to temporarily disconnect the battery.
__________________
1997 Silverton 362, 7.4 Crusaders
1997 2400 SCR, 5.7 Vortec / Bravo 2
Mike
|
|
|
10-10-2015, 02:40 PM
|
#10
|
Lt. Commander
Join Date: May 2014
Posts: 136
|
I had that problem while running. Found out it was a bad Idle Control Valve. Make sure you change little filters to as that is what makes the Idle Control valve go bad. Agree with mmwjr, disconnect battery temporary.
|
|
|
10-10-2015, 02:41 PM
|
#11
|
Lt. Commander
Join Date: May 2014
Posts: 136
|
Oh I forgot, If Idle Control valve is bad, engine won't idle. That's what happen with me anyway.
|
|
|
10-10-2015, 05:00 PM
|
#12
|
Ensign
Join Date: Mar 2015
Posts: 6
|
Quote:
Originally Posted by Uncleted
I had that problem while running. Found out it was a bad Idle Control Valve. Make sure you change little filters to as that is what makes the Idle Control valve go bad. Agree with mmwjr, disconnect battery temporary.
|
Hi
What little filters
Thanks
|
|
|
10-10-2015, 05:15 PM
|
#13
|
Lt. Commander
Join Date: May 2014
Posts: 136
|
Lift the cover off of your (carburetor) I know its not the carburetor if you have fuel injection, but you will see a small foam like filter around the back edge. I Did see a picture somewhere but don't know where. Check engine manual. Again, they are a white foam, about 1-2 inches long down in the rear part.
__________________
|
|
|
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
|
» Recent Threads |
|
|
|
|
|
|
|
|
|
|
|