We just drove our 2005 Maxum 2900SE home today. Want to figure out how to use the Parallel power switch. Does it matter which power inlet (1 or 2) you plug in the 30 amp service to? Plus from what I've ready you leave show shore #2 power switch off and only turn on the Parallel switch? Is that correct? Will be hooking boat up to shore power tomorrow so wanted to make sure I got this right.
With one cord I plug into shore power one, then turn shore power switch one on, select parallel switch on, and then turn shore power two switch on. Not sure if there are other ways of doing it, but it works on my boat.
Parallel Show power switch
Linear Mode
