Hi everyone... I have an 03 ScR that I’m still getting used to. For some reason I have lost most water pressure In the galley sink. The other sinks work fine. The wand did have calcium build up which I cleaned but the pressure has not returned. This leads me to believe their might be an in-line filter. Before I go nuts. Is their a filter?
You cleaned the aerator and the pressure did not improve, correct? Do you have flow with the aerator off? There is no factory filter other than what’s on the pumps output.
Correct it did not change. With a full tank and the pump off yes I do have flow. Which is why I also think the vent tube is clogged. I have a lot of pressure when I open the water fill cap.
Correct it did not change. With a full tank and the pump off yes I do have flow. Which is why I also think the vent tube is clogged. I have a lot of pressure when I open the water fill cap.
I would think if the vent for the fresh water tank was clogged all of the sinks would be affected not just the galley. However if removing the fill cap causes an increase in pressure at the galley sink then I would look at replacing the fresh water tank vent.
03 scr 2500 galley sink
Linear Mode
