I have a 96' 1900SR Maxum bowrider with a 4.3LX and have 2 batteries in it. I want to put in a selector switch in. Got one with the boat but can't find anyplace to put it that would be easily accesible. Also with the wiring of it, the back has 3 places for wires. One says Comm which i get is for the power from the motor and the other two say 1 and 2. I am guessing the positive wires go to them. Where does the negative wire from the motor go along with the batteries?
Hope this picture helps. From the looks of it as long as the negative goes to a ground connection it'll be fine. The picture is kind of small. If it doesn't show up email me and I can send you the file.
__________________
__________________
1996 Maxum 2100SR, 5.7L V8, Alpha 1
2004 Chevrolet Avalanche Z71
“All that is necessary for the triumph of evil is for good men to do nothing.” - Edmund Burke
P.S. this is the setup I'm going to eventually put in.
__________________
1996 Maxum 2100SR, 5.7L V8, Alpha 1
2004 Chevrolet Avalanche Z71
“All that is necessary for the triumph of evil is for good men to do nothing.” - Edmund Burke
You don't need the isolator but it really makes it easier when charging either my running the alternator or by external source. I'm gonna go with the isolator eventually.
__________________
1996 Maxum 2100SR, 5.7L V8, Alpha 1
2004 Chevrolet Avalanche Z71
“All that is necessary for the triumph of evil is for good men to do nothing.” - Edmund Burke
Master Switch Location
Linear Mode
