I recently purchased a 99 3000 SCR. It was an impulse buy, price was too good to pass up. The rotary genset start stop switch on the breaker panel is snapped off. I did not have time prior to shrink wrapping for winter to pull panel and get any numbers off the switch. As the stem to the switch is very thin plastic, I figure someone else has had to replace one as well. Any ideas as to where to purchase the switch and what I need exactly would be greatly appreciated.
It's a Westerbeke, Model # 4.5CGTC. I think it might just be a standard 2 pole, rotary on off switch. 12 volt, probably fairly low amperage, judging by the schematics.
Genset Start Stop Switch
Linear Mode
